disconnect blower question

[slow poke]

Can it be done and still have the engine run fine? I was self tunning with PRP but have dead ended. The car as of now is untuned with a 4 lb lower, 2.8 upper, MAFia, ported blower, and BAP.

I have to transport it 200 miles where it will sit indefinitely, can I return the car to stock and disconnect the blower?

Thanks

 

[slow poke]

Return to a stock or base tune I mean, I dont want to spend any more time on it so removing mods is not happening

 

[joshcarp81]

I drove my car 50 miles out of boost to get it to the tuner.
that was with a pretty good base tune.
A crappy tune or no wideband would make me nervous.
especially that much further.
If you had a good base tune and stayed out of boost.....I'd say go for it....

 

[Tractionless1]

Disconnect the boost bypass valve and wire the armature open on the blower.

 

[slow poke]

Tractionless,

thanks, would this remove all boost? or still allow a protion of the incoming air to be compressed?

I would think as long as it does not get to more than 8 PSI I can just reload the stock tune for the car from the factory and drive it.

 

[Tractionless1]

From what I've read it should remove all boost.