I have an Auto Meter Water Temp Gauge for sale. The gauge will come with everything in the pics below. The specifications for this gauge can be found here... http://www.autometer.com/cat_gaugedetail.aspx?gid=2628&sid=7 This gauge will come with the original sender and an additional sender. The additional sender is Auto Meter PN: 2259. This sender is the same as the sender that comes with the gauge but smaller and can be used where clearance is an issue. More information about this sender can be found here... http://www.autometer.com/cat_accessoriesdetail.aspx?vid=33 The cool thing about getting two senders with this gauge is you can use one for the water temp and use the other for something else like trans temp or diff temp. Then you can flip back and forth monitoring both locations with the use of a 3 pole switch. I will include a 3 pole switch with this gauge so you have to option to wire it up that way if you want. It's very easy to do. You just put the senders where you want them, run a wire from one sender to the bottom pole of the switch, run another wire from the other sender to the top pole of the switch, and then run a wire from the center pole of the switch to the appropriate spot on the back of the gauge. It's that simple. You can then use the switch to flip between the two senders and monitor two fluid temps with one gauge. I had it wired up for water temp and trans temp when I was using it. There is nothing wrong with this gauge except for the residue left from the sticker that was on the side. The sender works perfectly and the light still works. This gauge will not come with instructions but they can be downloaded here... http://www.autometer.com/productPDF/1079A.pdf Please check out the pics below and PM me with any questions about the gauge or how to wire it up. $30.00 shipped and I except PayPal, cashiers check or money order.