head gasket question ???

luis03cobra

New Member
Established Member
Joined
May 22, 2013
Messages
9
Location
Houston Tx
so i put my heads on using a felpro head gasket and arp studs and started putting timing chains on a couple days later when i turned the cam gear over so now im going to take driver side head off again to check for damage question is will i need new head gaskets since theyve been torqued down for a couple days or are they still good ???
 

luis03cobra

New Member
Established Member
Joined
May 22, 2013
Messages
9
Location
Houston Tx
Crank gear timing mark was at 6 o clock and I was putting tension on the cam gear to match up marks and went a little to far and it rotated over
 

hotcobra03

Well-Known Member
Established Member
Joined
Mar 11, 2007
Messages
7,461
Location
poteet,texas
From working on mine..if i did that..I keep putting it together....

I recall all pistons being low enough with dot at 6 and keyway at 10..

head gaskest would be trash if you remove head
 

Users who are viewing this thread



Top