• Welcome to SVTPerformance!

help for SHO

Discussion in 'Gen I, II, and III Taurus SHO' started by rcombs1, May 11, 2012.

  1. rcombs1

    rcombs1 New Member

    Messages:
    4
    Joined:
    May 10, 2012
    Location:
    kentucky
    Hey guys I am brand new here. Just sold my 86 mustang GT and bought a 93 SHO atx. I love this car. Need some help...
    The car was missing and idling rough. It still had original plug wires so I replaced the wires and plugs. Also replaced a couple vacuum lines. The car ran smooth for a while but now it bucks like a wild horse and has significant power loss. Where do I go from here. No check engine light but maybe it has been disconnected by previous own:shrug:
     
  2. NEp8ntballer

    NEp8ntballer Member Established Member

    Messages:
    208
    Joined:
    May 6, 2012
    Location:
    Lousyana
    make sure the plug wires are routed properly and that if you disconnected anything that it was plugged back in. if the tach is acting funny when it runs rough then the cam position sensor is on the way out. Post on www.shoforum.com as it gets more traffic than the SHO section here.
     
  3. zblackbeast

    zblackbeast New Member Established Member

    Messages:
    8
    Joined:
    Oct 1, 2012
    Location:
    Plymouth, CT
    What plugs did you use? The SHO likes the Autolite/Motorcraft and Denso plugs (yamaha motor).

    Also, check your CAM sensor and DIS module.
     

Share This Page