• Welcome to SVTPerformance!

Highest boost using centrifugal vortech or paxton with funtioning egr installed

Discussion in 'The Blower Bistro' started by Bill Anderson, Apr 28, 2013.

  1. Bill Anderson

    Bill Anderson Member Established Member

    Messages:
    275
    Joined:
    Feb 20, 2005
    Location:
    atlanta
    Hello Everyone,

    What is the highest boost you have seen on a vortech / paxton install with egr valve still installed?

    Trying to track down some boost leaks and am down to the egr, don't want to remove / block it unless absolutely needed.
     
  2. 01yellercobra

    01yellercobra AKA slo984now Established Member

    Messages:
    16,513
    Joined:
    Oct 5, 2005
    Location:
    San Diego
    What boost level are you seeing? What's your full set up? Pulley sizes, intercooler, ported heads, ect.

    Misspelling brought to you by Tapatalk
     
  3. Brutal Metal

    Brutal Metal Well-Known Member Established Member

    Messages:
    10,570
    Joined:
    Feb 2, 2009
    Location:
    Largo Florida
    with good fuel on a YSI or F1? A LOT!
     
  4. CPRsm

    CPRsm Authorized Vendor Authorized Vendor

    Messages:
    4,400
    Joined:
    Feb 3, 2009
    Location:
    San Diego, Ca
    20 w a check valve.
     
  5. Brutal Metal

    Brutal Metal Well-Known Member Established Member

    Messages:
    10,570
    Joined:
    Feb 2, 2009
    Location:
    Largo Florida
    An F1-R or X and YSI will produce MORE than 20lbs..
     
  6. mtrsprt

    mtrsprt New Member Established Member

    Messages:
    650
    Joined:
    Jun 4, 2009
    Location:
    NH
    If you want them to, then yes.

    To the OP.

    I ran 19psi (Ysi @ 52,000) with a functioning EGR just fine.
     

Share This Page