ok, just curious how fast would w/ bolt-ons & a 100 shot of n20 ls1 be?? would a regular pullied cobra be able to take it down??? just curious since im not a ls1 expert.
91hatch said:diffenitly no. an ls1 with boltons and a 100 shot will be in the low 11's
Slow03Cobra said:Simple...The Cobra traps higher than an LS1 w/ a 100 shot.
pewter99_trans said:Depends on what you want to call a regular pullied cobra...i dont know a ton bout cobras but a exhaust pullied cobra isnt going to make over like 450hp...a 100 shot bolt on trans am would def be over 450hp and lighter..
ls1eater said:Disagree.......Bolt on 100 shot ls1 should be mid to high 11's and they come out real good so trap speed would be lower or the same as a pullied bolt on cobra.....Now a bolt on cammed 100 shot is another story low 11's from those
pewter99_trans said:Depends on what you want to call a regular pullied cobra...i dont know a ton bout cobras but a exhaust pullied cobra isnt going to make over like 450hp...a 100 shot bolt on trans am would def be over 450hp and lighter..
dredg9 said:like some guys said you would have to be able to pull mid to high 11's at 118+ to hang with a decently modded one with a 100 shot.
machslammer said:Hmmm.. these posts are strange to me.
I ran a bolt on Ls1 with a 100 shot when I was in my 04 Mach. I had intake, exhaust, chip, 4.10, sts, and 100 shot. We did a ten roll since all my mach would do was spin with bald tires from a dig. We did a 15 roll. He pulled on me by a fender in 2nd, third we were even, and in high fourth i pulled a car. He never had his car dyno'd so i dunno what it was making, but my mach made 387hp and 470tq on spray. Have a vid, but my laptop won't load it. I will try to post this weekend. Oh, and I know my 03 cobra would drill my mach. Later