• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

I'm looking for a how to with photos

Discussion in 'SVT Shelby GT500' started by poiznus03, Feb 2, 2011.

  1. poiznus03

    poiznus03 2010 GT500 Established Member

    Messages:
    64
    Joined:
    Mar 11, 2007
    Location:
    Newport News, Va
    for lowering a 05-10 mustang. I actually have a 10 GT500 so if there is anything out there for a SHELBY, let me know. Seems I remember seeing something either here or some place else but the mind is the 2nd thing to go!:shrug:

    Thanks in advance for any help!
    Rudy
     
  2. Steve@BAS

    [email protected] Active Member Established Member

    Messages:
    1,853
    Joined:
    Mar 26, 2010
    Location:
    Florida
    look in the how to section (top of the gt500 page)
     
  3. poiznus03

    poiznus03 2010 GT500 Established Member

    Messages:
    64
    Joined:
    Mar 11, 2007
    Location:
    Newport News, Va
    Lowering

    I saw that. Just wondered if the 08 and 10 were similar in this respect. is there anything different in the 2010 setup that I should be aware of?
    Rudy
     
  4. Spawn

    Spawn mmjax.com webmaster Established Member

    Messages:
    906
    Joined:
    May 1, 2006
    Location:
    Jacksonville, Florida
    Just make sure you peel off the rubber isolators from the stock springs and put them on the replacements. Its really a simple job with the right tools. I purchased a spring compressor from Auto Zone when I did mine and have helped a bunch of friends lower theirs.
     

Share This Page