• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

JE Pistons (upgraded pins) and Oliver I beams.. Anyone have them?

Discussion in 'Engine/Tuning' started by StevenStarke, Oct 29, 2013.

  1. StevenStarke

    StevenStarke Fast/Reliable/Cheap pick2 Established Member

    Messages:
    1,259
    Joined:
    Sep 16, 2011
    Location:
    LI, NY
    I think I'm going to go with Je's with upgraded pins and Oliver I beam rods. I'm definitely over building it because I only plan to make 600-650whp on 93 and 850whp on E98 initially. Once I can do a trans in the future, I don't plan on ever making much more than 1000whp.

    Just want to see if anyone has used these. And if so, what compression? I'm thinking 9.5:1 but I COULD go with 11:1's and just run less boost. But I feel like that asking for trouble.
     
  2. Eric@jpc

    [email protected] New Member Established Member

    Messages:
    1,443
    Joined:
    Jan 23, 2012
    Location:
    Beltsville, MD
    We run Oilver I beams in alot of our stuff that makes big power.

    Cant say anything about the JE pistons i know they are a good company but from my understanding they can make noise.
     

Share This Page