JLT Oil Seperator hitting brace

[doublex]

I installed my new JLT Oil Seperator and I noticed that the top of the "can" is touching/hitting the bottom side of my FRPP brace. Has anyone else run into this, and if so what is the fix? I was going to put some sort of tape/pad on the bottom side of the brace, but wanted to see if anyone else had this issue.

I checked and I believe the connector is seated, but I'm open to suggestions.

Thanks.

 

[UnleashedBeast]

Looks like you may be able to adjust the can on the fittings to sit sideways for more clearance.

The ultimate fix is in my signature, good thread too.

 

[zporta]

I don't have an answer to your question

But how do you get your head cover bolts so clean?

 

[mullens]

Just tilt it a little it's not going to hurt anything.

 

[doublex]

I don't have an answer to your question

But how do you get your head cover bolts so clean?

Nothing special. Once or twice a year I use some dilluted Simple Green and spray throughout the engine compartment (cold), and then hose off. Dry off with a compressor/leaf blower, then followup with some vinyl dressing for the hoses/plastic and it's good to go.

 

[Robertt305]

My bad

 

[54First]

the top of the "can" is touching/hitting the bottom side of my FRPP brace.

Mine too. I put a strip of Velcro (the fuzzy half) on the brace.

Steve

 

[Tucker]

Mine too. I put a strip of Velcro (the fuzzy half) on the brace.

Steve

^^
The FRPP brace is much larger than stock.