MM forward offset control arms

[35thPonyGT]

I just bought a MM k member and control arms for the stang and don't know if the arms are the regular or forward offset!
Guy didn't know either. He bought the car as a roller and was putting a pushrod race motor in
Any measurements I can do outside of the car?

 

[Svtmustang01]

Id imagine if you set them over or under you stock a arms it will move the ball joint forward if its a forward offset.

 

[94slowbra1]

or call MM and ask them what the measurements should be.

 

[Bigggy]

I've asked that before to MM and that was the answer:

 

[35thPonyGT]

I've asked that before to MM and that was the answer

That's what I was looking for! Thanks a million

 

[Bigggy]

You're welcome! FYI, if you want to replace the ball-joint go with some stock ford ones. I've tried some cheaper balljoints and the design was different, they could have worked with stock LCA but not the tubular ones from MM. But I'm guessing the Steeda X2 would also work, similar design than stock.