I am in the process of installing a new clutch. I've got everything unbolted and trans slid back but there is not enough room for it to come back so the input shaft slides out of the clutch... Bell housing is buried into floorpan and engine can't tilt anymore.... What do I need to do to get this thing out so I can quit cursing ford engineers that designed this issue. Do you have to cram your hand in the bellhousing and separate it from trans for it to come out? I'm stumped and been fighting it for over an hour now. Please any experienced advice is greatly appreciated as my car is hung on lift at this time.
Thanks in advance!
Thanks in advance!