Hey guys, I'm attempting to install the CHE K member brace and torque limiters. 2011 and up have studs on the K member to hold the brace. The CHE instructions say to cut the head off. Any tips of how to do this? I cut off the head with a grinder. The bastard rotates in the hole but wont come out. There is still a half a millimeter of material where the head of the stud was.
switched to the dremel and got it finally.
Is there an easier way to do this next time?
switched to the dremel and got it finally.
Is there an easier way to do this next time?
Last edited:
