Hello everyone & good morning my name is Victor! I am looking for a little insight on a job Im in the middle of & it's kicking my rear end. I believe from all the research I've done that the pumpkin is cast steel & should be welded with a nickel rod. What I cant find is to what temperature I need to heat it up to & at what amps to weld at. I am trying to tig weld the axle tubes along with the center housing for support & its been a hit & miss. Some of my welds held just fine while others did not. Im not a certified welder by any means & Im at a loss on what Im doing wrong. Any & all help is appreciated. Thanks!
Sent from my SAMSUNG-SM-G928A using the svtperformance.com mobile app
Sent from my SAMSUNG-SM-G928A using the svtperformance.com mobile app