Stock height/suspension Shelby?

[MovingZen]

Do you have a 13/14 Shelby with no suspension modifications?
If anybody has a moment, no rush, I'd appreciate measurements to the apex of each fender from the ground on a flat surface. I would like to have one of my presets on my air lift system to put me at stock ride height. It's been so long since I've had a stock suspension I can't even guestimate where I should try to set the height.

Thanks in advance :beer:

 

[PowerWheels]

I can get you started, the picture in your sig is not stock height!

 

[MovingZen]

You sir, are no help at all! lol
I could look at pictures and approximate, but I'd like to be a little more exact. ocd man, ocd. Plus, I need to get two people to sit in the car while I do the measurements.

 

[5.8 Venom]

Stock 820a car. GY tires measured straight up the center of the wheel from ground to fender lip. Front 28 7/16 - Rear 29 3/4

 

[MikeHoncho]

Stock 820a car. GY tires measured straight up the center of the wheel from ground to fender lip. Front 28 7/16 - Rear 29 3/4

^^This.

 

[MovingZen]

^^ bonus round

Thank you gentlemen!! :beer:

 

[01mingreyvert]

Does anyone have sport lines with stock wheels. I have a pro kit and are about to put on BMR sp009 springs and will report back what the heights are. As for the Eibach pro kit front is 28 1/8 and rear is 28 3/4

 

[MovingZen]

I need to measure mine at my lowest ride height and see how it compares. I also need some one who is 190 lbs so I can set the stock height.

 

[delvek]

You didnt read the tape measure correct, the front is not 7/16! Its between 7/8 or 15/16!

If it was 7/16 it would be the first mark past 3/8.

 

[Snoopy49]

This is from my 2013 GT500 with Performance Package (821A). 3200 miles, stock tires, suspension and no driver or passenger.

Drivers side.
Front - 28 3/4"
Rear - 29 5/8"

Passenger side.
Front - 28 7/8"
Rear - 29 3/4"

All measurement taken from the centerline of the wheel, floor to top of fender opening.