• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

SUGGESTED MACHINED SHOPS FOR 4.6 4V REBUILD

Discussion in 'South' started by SPT98SNAKE, Jun 2, 2021.

  1. SPT98SNAKE

    SPT98SNAKE New Member

    Messages:
    9
    Joined:
    May 10, 2021
    Location:
    Blacksburg, VA
    It's time to rebuild the engine in my 98 COBRA. I bought the car relatively cheap last year in a non-running condition. It turned out that the passenger side intake cam was frozen due to a lubrication failure. I'm new to the 4.6 engines and have been doing research to come up to speed. I know that the aluminum blocks (TEKSID in this case) are particular when it comes to machining. Does anyone have recommendations for experienced machine shops in the mid-Atlantic that understand these blocks? I'm located in SW Virginia. Thanks.
     

Share This Page