• Welcome to SVTPerformance!

Teksid block question

Discussion in 'Engine/Tuning' started by sean r, Mar 22, 2013.

  1. sean r

    sean r New Member Established Member

    Messages:
    230
    Joined:
    Dec 5, 2012
    Location:
    norwalk ct
    So I was thinking of picking up one of these blocks just to have on hand incase a rebuild is needed and would switch over to the lighter block at that time. Does the front timing cover from a terminator work on this block or would i need to pick up the matching timing cover for the teksid. Also any other things or is it just a strait swith of parts. Thanks sean
     
  2. 520Terminator

    520Terminator Wait.....What? Established Member

    Messages:
    337
    Joined:
    Oct 31, 2012
    Location:
    Tucson
    I believe you must use the Termi timing cover, as it has the provisions for the pulley bridge. The Termi cover will fit the Teksid block, but IIRC there is one bolt hole that doesn't line up. Most people just leave it out.
     
  3. racebronco2

    racebronco2 Active Member Established Member

    Messages:
    7,266
    Joined:
    Sep 23, 2003
    Location:
    palmdale, ca
    We just silicone where the missing bolt is at.
     
  4. sean r

    sean r New Member Established Member

    Messages:
    230
    Joined:
    Dec 5, 2012
    Location:
    norwalk ct
    Cool thanks for the info. Btw is it the teksid block that has the extra bolt hole or the terminator tc cover that will have a blind hole.
     
  5. cozmo2806

    cozmo2806 up in dat azz Established Member

    Messages:
    1,335
    Joined:
    Oct 15, 2007
    Location:
    28115
    The timing cover will have a blind hole.
     
  6. sean r

    sean r New Member Established Member

    Messages:
    230
    Joined:
    Dec 5, 2012
    Location:
    norwalk ct
    Thanks for the info.
     

Share This Page