My 03 is currently having a new pressure plate, clutch disc TOB is being replaced. The fingers on the plate were out .026 in. You could see where the bearing was catching on the fingers. The collar on the tranny is fine. My mechanic said that he had never seen a TOB quite like this. (a self centering bearing). Any ideas on this? Are aftermarket bearings able to move the centers from side to side? What is the definite fix for this. I am aftaid it will come back and have to do this again. The mechanic said he may put a small spring on the linkage to prevent continous running of the bearing. Is this a good idea? Any help is appreciated.
gw
gw
