• Welcome to SVTPerformance!

vortech strim 3.33 pulley serpentine belt length?

Discussion in 'SN95 Cobras' started by 97RioRed4V, Jun 30, 2014.

  1. 97RioRed4V

    97RioRed4V Member Established Member

    Messages:
    118
    Joined:
    Sep 17, 2012
    Location:
    Peoria, IL
    I am installing the belt on my 97 with vortech strim 3.33 pulley. I have a napa 25-061120 which is 112.625 inches. I tried to install it and seemed not to fit . I had the tensioner fully released and I could not get the belt over the water pulley. Do I have the right belt size?
     
  2. COBRA97SVT

    COBRA97SVT Active Member Established Member

    Messages:
    1,488
    Joined:
    Aug 16, 2007
    Location:
    Southwest MI
    Go with a 113" Belt.
     
  3. 97RioRed4V

    97RioRed4V Member Established Member

    Messages:
    118
    Joined:
    Sep 17, 2012
    Location:
    Peoria, IL
    Thanks Cobra! If you happen to have the part number please send it. I guess I will have to go through the pain of removing the bracket again??
     
  4. COBRA97SVT

    COBRA97SVT Active Member Established Member

    Messages:
    1,488
    Joined:
    Aug 16, 2007
    Location:
    Southwest MI
  5. LDC2335

    LDC2335 Active Member Established Member

    Messages:
    1,997
    Joined:
    Feb 26, 2009
    Location:
    USA
    I'm using the 3.60 pulley but could barely get this one on. Might be perfect for you.

    uploadfromtaptalk1404258080844.jpg
     

    Attached Files:

    Last edited: Jul 2, 2014
  6. 1996MysticSnake

    1996MysticSnake Active Member Established Member

    Messages:
    936
    Joined:
    Jan 28, 2007
    Location:
    PA
    I run a 112.5 and have zero belt slip
     
  7. 97RioRed4V

    97RioRed4V Member Established Member

    Messages:
    118
    Joined:
    Sep 17, 2012
    Location:
    Peoria, IL
    Sorry didnt see all these post earlier. Monday night I went to napa and bought a belt that was 112 and 7/8. It was tight but fit. I wish I saw the summit one above earlier. My belt was around $50! Since they are independently owned, they claimed that the napa online price doesn't need to match the in store price! The part number I used is Micro-V 25-061123. I think the 113 and 5/8 would work too.
     
    Last edited: Jul 2, 2014

Share This Page