• Welcome to SVTPerformance!
ATTENTION!
You may experience intermittent issues while accessing the site over the next 60-90 minutes, as we perform maintenance and upgrades.

Where to tap POWER wire for Wideband?

Discussion in '2nd Generation' started by TheFranchise, Jan 20, 2008.

  1. TheFranchise

    TheFranchise New Member Established Member

    Messages:
    568
    Joined:
    Feb 18, 2006
    Location:
    Houston, TX & Palms Springs, CA
    I could have it go to my battery, but don't really want to do that. Is there any EASY way to tap into another source close to under the dash or somewhere?

    For my AEM Wideband.
     
  2. RIDE THE

    RIDE THE Shake & Bake Established Member

    Messages:
    5,766
    Joined:
    Jan 17, 2006
    Location:
    NORTHERN VIRGINIA
    Power point socket power feed.
     
  3. TheFranchise

    TheFranchise New Member Established Member

    Messages:
    568
    Joined:
    Feb 18, 2006
    Location:
    Houston, TX & Palms Springs, CA
    Umm...where!? lol
     
  4. RIDE THE

    RIDE THE Shake & Bake Established Member

    Messages:
    5,766
    Joined:
    Jan 17, 2006
    Location:
    NORTHERN VIRGINIA
    Cig lighter element in the dash............ right next to it is the power point.

    You know, where you plug in your cell phone charger.

    If you want a constant 12 volt power source just tap into the power feed to the power point.

    If you want a switched 12 volt power source or an alternate to the power point circuit tap into the wires at the ignition switch.

    Ignition switch wiring diagram:
    StarterWire.gif
     
  5. TheFranchise

    TheFranchise New Member Established Member

    Messages:
    568
    Joined:
    Feb 18, 2006
    Location:
    Houston, TX & Palms Springs, CA
    Thanks a lot!!
     

Share This Page