• Welcome to SVTPerformance!

Will a 2011 GT500 header bolt right on a 2010 GT500?

Discussion in 'SVT Shelby GT500' started by Yoda Master, Jul 14, 2019.

  1. Yoda Master

    Yoda Master New Member

    Messages:
    4
    Joined:
    Jul 9, 2019
    Location:
    Seattle
    Was wondering if the 2011 GT500 headers would bolt on a 2010 Gt500. Anyone know?
     
  2. RBB

    RBB Well-Known Member Established Member

    Messages:
    1,277
    Joined:
    Jul 3, 2013
    Location:
    Stephens City, VA
    Yeah, the primaries will. I believe the only difference is your over axle pipes are 2.5” on a 2010 instead of 2.75” on an 11-14. So make sure you get the 2010 specific midpipe if you’re still running the stock OA pipes.
     
    lexustech48 and me32 like this.
  3. Yoda Master

    Yoda Master New Member

    Messages:
    4
    Joined:
    Jul 9, 2019
    Location:
    Seattle

    Thanks, I talked with ARH, Bassani, and SW, they say the driveshaft, possible way it aligns could be different
     
  4. RBB

    RBB Well-Known Member Established Member

    Messages:
    1,277
    Joined:
    Jul 3, 2013
    Location:
    Stephens City, VA
    That’s a new one, never heard that before.
     
  5. 69b302

    69b302 Active Member Established Member

    Messages:
    449
    Joined:
    Feb 26, 2007
    Location:
    NY
    The later years dropped the exhaust hangers from the trans cross member, IIRC. As others have mentioned the diameter was increased to 2.75. Not sure how the driveshaft comments relate, as really no changes till 13/14s went one piece CF, and even then not sure how it could effect header fit.
     

Share This Page