Lower crank loser making noise?

[Quagmire]

I have a 4lb lower and crank pulley is lose and making a racket any heard of these doing that? Should i tighten it up and see what happens or is it more serious than just a lose damper nut. Just for reference the pulley is secured to the plate but its the damper part that is lose.

 

[Jimmysidecarr]

Get in there and find out exactly what is loose.

If there is no damage or misalignment then tightening and adding loctite should be ok.

 

[Quick Strike]

You know the answer is to investigate the cause. An aftermarket hub can also come loose from the dampner. So that is a possibility if you have an aftermarket lower set-up.

 

[Quagmire]

ya i think the hub is lose started making a knocking noise , Just gotta wait for snow to melt should be here this week hopefully all it needs is a good tighten.

 

[Quagmire]

Was one of the three hex bolts that hold the hub on was about 4 turns out. Tighten it up noise went away tom taking them all off and putting lock tight on them so this shit don't happen again.

 

[Robertp]

Direction call for red loctite