UPDATE: CAR IS SOLD!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! 03 sonic blue cobra coupe, 6,xxx miles , this car has everything top quality on it. To start off it has my automatic 4r70 transmission conversion with precision custom convertor, full throttle lock-up convertor and overdrive for nice highway cruising! The rear is a slightly narrowed solid axle with welded tubes and every high strength upgrade I could do to it, fully studded, solid pinion shim, 3.73 ford racing gears and a 600.00 custom detroit locker carrier, and ford racing girdle. The rear suspension consists of custom rate rear springs with ford racing upper arms and steeda aluminum weight jacker lowers that can be adjusted to suit whatever wheel or tire you have on it....this car works...it went a 1.36 60 ft with this setup!
The car has a sonic blue painted cage with removable side bars fully custom and fabbed from 4130 chrome moly. the interior is has 04 cobra dark charcoal seats front and rear and autometer cobalt boost, fuel pressure and coolant temp guages. It uses a factory mach-1 shifter and the install looks factory. It also has a blue led raptor shift lite. The front suspension is chrome moly upr k-member and a-arms with q-a1 aluminum struts and coil overs held up top by ford racing(global west) caster camber plates It also uses my custom dual pass heat exchanger with dual spal fans mounted to it with a vortech cooler tank. It also has a custom big radiator and lincoln mk-8 cooling fan so it stays cool even here in Florida!:rockon: the charging system is upgraded front to back with a 180 amp alternator and 1 guage welding cable for very low power losses to the car, also has a NHRA required rear battery shut off switch. The fuel system is upgraded front to back too with factory pumps with my dual relay power upgrade using a BAP, #8 braided fuel lines to a cleanable billet fuel filter up to cpr rails and flow matched 60 lb. injectors. An sct 2800 air meter and one of my custom SCT tunes controls the brand new engine, which was built by the best modular engine builder in the country, Al Papitto of Boss330 Racing in vero beach Florida. Anyone who knows anything about modular ford racing engines knows Al....his engines are the best. This new engine started out with a production block and is fully studded with all arp hardware and is fully blueprinted, using custom C-P pistons and billet Manley connecting rods to have the ability to support over 1,000 h.p easy!:rockon: The heads are ported and have stainless valves with a custom valve job and lightweight springs. Sitting on top of this unreal engine is a new Kenne Bell 2.8 polished supercharger , I have pullies for various boost levels to suit whatever you want to do, cruise or race...also it has a Metco lower blower drive with many custom parts in the blower drive. The car has new Bassani headers and x on it with a magnaflow cat back. I'm sure i'm forgetting something but lets just say this car is setup with the best parts and the workmanship is show quality on top of being a 6,000 mile sonic blue cobra, which is hard enough to find!!:burnout: Send me e-mail at [email protected], p.m. me or call 813-241-2783 if you need more details on the car. The price will reflect the way you want the car setup and with what parts.and what wheels. Thanks for looking, Hermann<a href="http://img174.imageshack.us/my.php?image=dsc00246ms3.jpg" target="_blank"><img src="http://img174.imageshack.us/img174/3013/dsc00246ms3.th.jpg" border="0" /></a><a href="http://img237.imageshack.us/my.php?image=dsc00244id2.jpg" target="_blank"><img src="http://img237.imageshack.us/img237/5051/dsc00244id2.th.jpg" border="0" /></a>
<a href="http://img170.imageshack.us/my.php?image=dsc00241mw0.jpg" target="_blank"><img src="http://img170.imageshack.us/img170/3893/dsc00241mw0.th.jpg" border="0" /></a>
The car has a sonic blue painted cage with removable side bars fully custom and fabbed from 4130 chrome moly. the interior is has 04 cobra dark charcoal seats front and rear and autometer cobalt boost, fuel pressure and coolant temp guages. It uses a factory mach-1 shifter and the install looks factory. It also has a blue led raptor shift lite. The front suspension is chrome moly upr k-member and a-arms with q-a1 aluminum struts and coil overs held up top by ford racing(global west) caster camber plates It also uses my custom dual pass heat exchanger with dual spal fans mounted to it with a vortech cooler tank. It also has a custom big radiator and lincoln mk-8 cooling fan so it stays cool even here in Florida!:rockon: the charging system is upgraded front to back with a 180 amp alternator and 1 guage welding cable for very low power losses to the car, also has a NHRA required rear battery shut off switch. The fuel system is upgraded front to back too with factory pumps with my dual relay power upgrade using a BAP, #8 braided fuel lines to a cleanable billet fuel filter up to cpr rails and flow matched 60 lb. injectors. An sct 2800 air meter and one of my custom SCT tunes controls the brand new engine, which was built by the best modular engine builder in the country, Al Papitto of Boss330 Racing in vero beach Florida. Anyone who knows anything about modular ford racing engines knows Al....his engines are the best. This new engine started out with a production block and is fully studded with all arp hardware and is fully blueprinted, using custom C-P pistons and billet Manley connecting rods to have the ability to support over 1,000 h.p easy!:rockon: The heads are ported and have stainless valves with a custom valve job and lightweight springs. Sitting on top of this unreal engine is a new Kenne Bell 2.8 polished supercharger , I have pullies for various boost levels to suit whatever you want to do, cruise or race...also it has a Metco lower blower drive with many custom parts in the blower drive. The car has new Bassani headers and x on it with a magnaflow cat back. I'm sure i'm forgetting something but lets just say this car is setup with the best parts and the workmanship is show quality on top of being a 6,000 mile sonic blue cobra, which is hard enough to find!!:burnout: Send me e-mail at [email protected], p.m. me or call 813-241-2783 if you need more details on the car. The price will reflect the way you want the car setup and with what parts.and what wheels. Thanks for looking, Hermann<a href="http://img174.imageshack.us/my.php?image=dsc00246ms3.jpg" target="_blank"><img src="http://img174.imageshack.us/img174/3013/dsc00246ms3.th.jpg" border="0" /></a><a href="http://img237.imageshack.us/my.php?image=dsc00244id2.jpg" target="_blank"><img src="http://img237.imageshack.us/img237/5051/dsc00244id2.th.jpg" border="0" /></a>
<a href="http://img170.imageshack.us/my.php?image=dsc00241mw0.jpg" target="_blank"><img src="http://img170.imageshack.us/img170/3893/dsc00241mw0.th.jpg" border="0" /></a>
Last edited:
