FEELER: 110% Complete Eaton Swap Kit

GM2Ford

Active Member
Established Member
Joined
Oct 16, 2012
Messages
625
Location
Michigan
Everything would be sold as a complete kit. Nothing will be parted.

Main highlights.

Stage 4 Stiegemeier Ported 04 Eaton Blower w/ ERG harness(50k)
Lower Intake w/ cooler(50k)
Ported 04 Cobra TB(5k)
Afco H/E w/lines(50k)
04 Cobra Coil Plugs(20k)
Coolant Cross Over
04 Cobra Thermostat w/ housing & hoses
New Oil Cooler w/ New housing
04 Cobra Tank with Pumps & Harness(20k)
Injectors, Rails & MAF, Air filter w/ housing(20k)
Timing Cover, All Pulleys, Alterna, Belts
IACV(new), TPS(new), Throttle Cable, 04 Cobra PS Pump & Power Steering Res w/ housing & lines(50k)
All PCV Lines & Hoses
New Felpro Gaskets for the Lower Intake, Oil Filter Housing, TB, T Cover are included as you will need them.
All Bolts will be left in individual labeled bags & or left on the part( stationary) for your convenience.

That's a round of it all. It is a complete, nothing missing swap. No cut corners, no boost a pump the gas tank with Pumps is there. Everything is there. If I haven't labeled it, its there & included for a complete swap into a 99-01 Cobra, 03-04 Mach or Marauder. I had sure everything was low miles & functioning nothing less than perfect & clean.

99% percent of you guys know what so called complete Eaton Swaps go for, and they MAYBE will include 70/80 percent of everything I have unless you find some type of donor car that isn't F'd up. Which still will not have the newer & upgraded parts that I have.

No more looking, no more searching for stupid little parts for months & months. Its all here.

No part outs. Complete Kit. Make an offer, worst I can say is no.

Also, what do other Terminator people think this is worth?
 
Last edited:

llvllanifest

Active Member
Established Member
Joined
Sep 23, 2013
Messages
432
Location
Lubbock Texas
I would have to say $3000 is a reasonable price
tag considering what all they are getting( a complete swap) ,should sell very quickly
 

H8TOLUZ

Member
Established Member
Joined
Aug 21, 2013
Messages
186
Location
kansas
Just did my swap with some new parts and didn't do gas tank. You don't need power steering pump....just pressure line and reservoir bracket. I have $3200 invested with some new parts and stock eaton. And HOURS of searching for parts! I would think 3k would be good price because it can be done for $2500 if a guy was patient but a complete kit makes it nice!
 

GM2Ford

Active Member
Established Member
Joined
Oct 16, 2012
Messages
625
Location
Michigan
For People who are PM'ing me. All Lines, Brackets, Nuts, Bolts etc. etc. are included with EVERYTHING you will need to this swap kit! They ONLY thing you would need to do yourself is modify your harness a bit which takes no time at all.
 

Users who are viewing this thread



Top