2.76-4lb lower, 3.2 alt belt size?

[kezell]

I tried to search....If there is a thread about this please direct me to it.

I am looking for a belt to fit the following...

2.76 upper
4lb lower
100mm snub idler
3.2 alternator pulley
rest is stock

If you have any recommendations please let me know.

Thanks for your time!

 

[lxhatch302]

If you want that bitch to be super tight 78 5/8... It takes two people to put the belt on and you have to remove the 100mm idler to do it.. One holds down the breaker bar(or whatever you use) and the other pushes like a mofo to get the idler back on...

Or get a 79" belt

 

[cobrakon]

I run a 2.76 upper, 4lb lower, 3.2 alt. pulley, and the 4 piece billetflow idler set. I was running an 80" belt but recently switched to a 79" gates belt. The 79" belt is real tight. Don't know if that will help. You can also check this site if you have not already.

Belt Selection Guide

 

[03 TOPLESSSVT]

If you want that bitch to be super tight 78 5/8... It takes two people to put the belt on and you have to remove the 100mm idler to do it.. One holds down the breaker bar(or whatever you use) and the other pushes like a mofo to get the idler back on...

Or get a 79" belt

Thats how you want it so there's no slip. If you dont have to take the idler off than it's NOT tight/right!

 

[anthony0979]

I have this exact set up...79 inch gates or gatorback will work.

 

[04svtsnke]

I run a 2.76 upper, 4lb lower, 3.2 alt. pulley, and the 4 piece billetflow idler set. I was running an 80" belt but recently switched to a 79" gates belt. The 79" belt is real tight. Don't know if that will help. You can also check this site if you have not already.

Belt Selection Guide

is your tensioner notched?

 

[kezell]

I ordered a 79" Gates this morning. Once I get it all installed I will post up the result on the belt size.

Thanks guys!

 

[cobrakon]

is your tensioner notched?

The stop has actually been completely removed.

 

[snakerider]

subscribing