Selling the 2003 cobra to buy a house. 72,500 miles asking $18000 but price is negotiable. Stage 5 steigmier port with 100 shot nitrous spray. I cant find the dyno sheet but car was tuned by psi motorsports in league city,tx and made 518 hp on motor and 613 hp on spray on a hot/humid summer day. Don’t remember the actual tq numbers but it was high 400’s and high 500’s. Current spray pill is 100 shot thru throttle plate but I have the 125 pill too.
Please call 281-795-8398, title in hand, serious inquires only
The good
Stegemier stage 5 port with ported accufab plenum and nitrous plate (plate ported by local guy) 4000 miles
Nitrous wet kit w/nitrous plate 20lb bottle, throttle activated, rpm switch, bottle warmer
Sct tuner with motor tune and nitrous tune
ARP head studs
Kooks long tube headers
Bassani exhaust with 4” tips
Accufab throttle body
2.93 upper
6lb lower
Idler pulleys
60lb injectors
Mafia
Kenne bell bap
Lfp heat exchanger
Head cooling mod
Cai
Spec stage 3 plus clutch (5500 miles) upgraded shaft sleeve, hd throw out bearing, new clutch fork
Irs brace
New water pump
Alternator rebuilt at local shop (not a cheap autozone type)
1yr old battery
a/c blows very cold
irs was resealed at 66,000 miles
subframes
lowered
no leaks
Flat out hauls ass and gets compliments almost every time I take it out
Psi motorsports did the ARP head stud work, nitrous and bap install at 67,000 miles. (have receipt) Ported blower went in at same time.
The bad
rock chips on the hood
idiot backed into left rear quarter panel, has since been pushed out but still has some small waves. Not bad and some people don’t notice it
heater core has been bypassed I believe when head cooling mod was done
Please call 281-795-8398, title in hand, serious inquires only
The good
Stegemier stage 5 port with ported accufab plenum and nitrous plate (plate ported by local guy) 4000 miles
Nitrous wet kit w/nitrous plate 20lb bottle, throttle activated, rpm switch, bottle warmer
Sct tuner with motor tune and nitrous tune
ARP head studs
Kooks long tube headers
Bassani exhaust with 4” tips
Accufab throttle body
2.93 upper
6lb lower
Idler pulleys
60lb injectors
Mafia
Kenne bell bap
Lfp heat exchanger
Head cooling mod
Cai
Spec stage 3 plus clutch (5500 miles) upgraded shaft sleeve, hd throw out bearing, new clutch fork
Irs brace
New water pump
Alternator rebuilt at local shop (not a cheap autozone type)
1yr old battery
a/c blows very cold
irs was resealed at 66,000 miles
subframes
lowered
no leaks
Flat out hauls ass and gets compliments almost every time I take it out
Psi motorsports did the ARP head stud work, nitrous and bap install at 67,000 miles. (have receipt) Ported blower went in at same time.
The bad
rock chips on the hood
idiot backed into left rear quarter panel, has since been pushed out but still has some small waves. Not bad and some people don’t notice it
heater core has been bypassed I believe when head cooling mod was done
Last edited:
