So over the summer the ball joints that came with my upr control arm/k member kit went bad and I replaced them with Moog balljoints. Went to get an alignment this weekend and the tech tells me the ball joint is sliding out of the control arm. Has any one had this happen before?
Upr control arm ball joint popping out
- Thread starter 97DarkSnake
- Start date
call UPR
I'd check with UPR also but I did have something similar happen on a different car.
Took the ball joint back and it was a few thousandths smaller and didn't press fit in tightly.
Took the ball joint back and it was a few thousandths smaller and didn't press fit in tightly.
Users who are viewing this thread
