52merc's latest activity

The 2-pin connector in the picture with your gloved hand I believe is a fuel injector connector. Likely the right front injector (Inj-1)...

The green connectors are for the front O2 sensors. Here is the information on the connectors for the O2 sensors: C168 - Green housing...

King Bearings are the most popular for the 4V engine. I believe the MB5283HP for mains is what you want, and for rods CR 868HPN. There...

Is there some reason to pull the engine apart? What are your ultimate goals? What is your definition of "full bolt ons". What horsepower...

The Fuel pump module in the trunk is connector C451. Pin-3 (RD-BK) is power [+] to the fuel pump. Pin-10 (BN-PK) is negative [-] to the...

1) You can bend it as said previously. 2) You got it. The Christmas Tree retainer pushes in there. Damn, I thought my engine bay was...

Here is a picture of that harness bracket from my car. It is held in place by the stud-bolt on the front of the engine mount and is in...

I have a Ford Shop Manual on CD but it does not show how this harness is run. All the engine bay reference is from above, none below. I...

You would need to go with a piston that is -1 cc or less. There are a few around but may be too costly for what you are trying to do. My...

Using the following specs and the DSS 1-FX piston: Bore Dia.=3.582" Stroke Length=3.543" Rod Length=5.933" Compression Height=1.210"...

Here is the schematic for the fuse box wires. Pic 1 are the Circuits 290 (GY) and are the two fusable links that splice into Circuit 38...

Can you imaging if that guy tried to do some port cleanup around the valves? It has been said, but needs to be said again, 'Some people...

Could those "white wires" actually be gray? Two gray wires merge into a single eyelet that is attached to the front side power terminal...

The MACH460 radio draws power through Fuse-32 (15 A) as does the GEM. It is not clear, if the amp on/off circuit is always drawing power...

I had the battery drain issue and it was from one of the MACH460 amps. Found out by unplugging the amps. Only one was bad so for months...