03 black coupe with 80,000k miles. Paint is flaking from the sun. Been sitting a while. Interior in good condition. Drivers rear quarter panel dented and scoop Unclipped (stored in trunk).
Ported stock blower, 2.76 upper, 5# lower, 40k on Ford remanufactured engine, mow shifter, bassani catted...
Interesting information. But I believe that there were lessons Ford learned from this project that we are now beginning to witness and that will benefit drivetrain development in the long run. These lessons would not have been learned had the 5.2 not been FPC. The lengths gone to in order to...
I have non-op'd my '03 for the last couple years after some kind soul scraped mine off in a parking lot. scraped a ton of paint, dented the fender, and tore the scoop to smithereens.
I have been out of the scene for a few years after I bought a new daily driver and temporarily retired the...
Not sure if this is the right department, but I need help!
I have searched this forum and not come up with the exact help I need.
Youtube has exactly one video of the info I need, but the video SKIPS the part I actually need!
Basically, I replaced my heater core last year. A couple...
I just took my car with a near brand new engine to the test center and it ended up being a gross polluter... :(
I had the exact same set up with an old and busted engine and it passes cleanly two years ago.
One change - my blower is now ported and has been tuned accordingly.
perhaps...
OK.
I had a new engine and new clutch, flywheel, pilot bearing (ford racing), throwout bearing and retainer sleeve (lethal) put in at a good shop a little over three months ago. I have broken the engine and clutch in gingerly and have been saving to get my car dyno tuned.
In the meantime, I...
I really only need my spoiler touch up, the mirrors, the rear bumper and a door handle.
Some wiseguy at wal mart scratched the bumper pretty good.
anyone know of a trustworthy shop?
How much would I be looking at in charges?
I have been saving my poor pennies for nearly two years to get a new engine in my car (reman Ford). Finally had it done. Great work by the shop. They seem to have gone the extra mile.
While putting in the engine, I had a brand new Centerforce Dual Friction clutch, Fidanza aluminum...
Just had my engine replaced at the shop.
Now I get a phone call telling me that while they were burping the cooling system, that the fan no longer works?
arrghh!
I have heard of these fans going bad at various mileages. Perhaps after sitting with a bad engine, the fan locked up?
anyone...
I was browsing movie trailers on apple.com when something struck me.
This Summer. 2011 - is the best movie summer in the history of movies. Not due to any ONE title. But each could carry the summer on its own. I am totally as nerdly excited as I can be.
Think of it:
Cars 2, Transformers 3...