Recent content by aloo1

lasota racing sent me a tune I was able to use my sct handheld for just the delete and it was only about $50. This was like 10 years ago so pricing may be different.

Thanks for the pictures Jredline. If I might try to tackle this project this weekend! Or at least get my seats out and take a closer look to see exactly how to match up what you did in your pics. Did you snip the sn95 plug from your old seat and connect it to you s197 seat so it would plug...

My driver is trashed but my passenger is still good. If you need that one and you're local to me in GA then you're more than welcome to come check it out if you need it.

yes pics please. And I promise my weld will look worse haha.

What did you do about the driver side? Or is that the driver side and you used manual tracks for both?

My dad's 95 cobra would only start with starter spray and then the second you got on the throttle anymore than a couple hundred rpm's it would stall out... Replaced the MAF sensor and all was good. Look there to see if that could be an issue.

That looks great. Could you adjust the seat to where the front is right under the steering wheel when adjusted to the highest setting and measure the distance between so i'll have an idea of how much lower they sit then my current seats. And I too would like to know if you used a spacer and if...

That would be great, thanks! I'm back and forth about using a manual track on the driver to save weight and simplicity.

double tap.. sorry

Oh I hear ya on the working in the south east heat....Kills motivation real fast. Do you think if you would have used the s197 track, you would need the spacers. Does it only sit lower b/c you used the sn95 track or do the s197 seat and track sit low together. When you used the sn95 track...

After doing some more researching I've come across post that express what you have said. I'll jump it first but even if it kicks on when I jump it, that doesn't mean it's a bad switch if the pressure is low correct? If the pressure is too low the switch is doing its job and it won't kick over...

ahh gotcha. My buddy works in hvac so maybe he can help me with that. If it is shown to have good pressure, then am I looking to the compressor not kicking on? If so, could that be caused by a weak battery?

06 seats come with tracks. Would it be easier to use the 06 track, bolt it to half in square tube across the front and rear and then weld tabs to that to bolt into the stock location. By doing this I would just need to wire the power and ground connector to the new seat. Or use the sn95...

Put gauges where? On the battery to check voltage?

Can sits for couple months at a time then gets driven about 10 miles then sits again. Negative cable gets disconnected each time it sits. AC was recently recharged about a year ago. Last time (a few months ago) when I drove it, the AC worked fine. Tried to drive it yesterday and ac won't...