Recent content by FormulaFord

I was trying to build my 2011 Gt500 on fords site. I want kona blue with silver stripes. When I choose the svt performance pkg it says you cannot have that with the silver stripe package. Why? Any insight appreciated.

Just curious to what the average everyone is paying for a custom tune for a modded 03/04 Cobra?

If you are running a BAP with wire upgrade, GT pumps, PPRV delete and 60# injectors, do you need a modified FPDM? Any input appreciated.

Just need the intake from the filter to the throttle body. Thanks

What do you think I should ask for in this market for my 2003 Blk coupe if I decide to sell it? 27K miles SSR wheels w/nittos MM coilovers and bumpsteer kit IRS brace and urethane bushings 2.3 Whipple @ 17#s 60 inj KB BAP PPRV Delete Carbon fiber intake subframe connectors 28 spline...

Where did you mount your BAP pressure switch? I have a Whipple and just installed the BAP and am not sure where to install this switch. I know it has to be under the blower and or under pressure. Please help! Thanks.

Anyone have any input on these? Do they work?

I need input from anyone running a BAP. Has anyone had any regrets of buying one? I have just increased from 13# to 17# (whipple) and have 60# injectors and factory fuel pumps. Is the BAP a safe way to go?

Whats the difference between these two? I am getting my car back tomorrow and need a new MAF. Any help appreciated.

My engine is out getting a .020 overbore and Diamond pistons. Is there anything else worthwile doing to it that is cost effective horspower? Has anyone changed cams, extrude hone or ported heads that can chime in on their gains? Any input appreciated. By the way I have a whipple 17#'s and...

Anyone have any experience with a bad injector? Last night at the track I had the #7 injector flowing fuel into the cylinder and fouling the plug. Is this common? I have 60# MotoTron injectors. Are these any good? Any way to check these things? Any input appreciated.

Hey who would you have rebuild your engine (03 Cobra) or would you buy an assembled long block from ?

Ok. I put a new set of plugs in and they all look in uniform except one. I do not know the cylinder number but it is on the drivers side 2nd from the back. The plug is black! What do you think? Oil from valve seals, piston ring problem, coil not working? Any opinion appreciated.

I just installed a new spec 3 clutch and Fidanza flywheel. My question is: The clutch fork with the old clutch in was all the way towards the rear of the car, with the spec it does not contact the pressure plate to half way pulled back. I have an adj cable and firewall adjuster (quadrant too)...

Anyone install one of these kits that has some decent install pics?