Recent content by lawdude

I'd like to have an easy way to drain my tank when I want to put C16 in. I can upload a program to turn on my fuel pumps. Has anyone used a Schrader valve on their fuel rail to drain your tank? If so, I'd like to know how what you use to connect to it.

I need to know which pin is ground and which is switched hot.

Driver side upstream O2 heater problem. Replaced the sensor. Still get the code. I assume it must be a problem prior to the sensor. Any suggestions?

My engine is out and apart. Already have stronger springs from previous rebuild. Anyone looking to get rid of their aftermarket cams fast? Want more hp. I'm fine if they lope.

Oops. Wrong forum. Deleted

Getting new pistons and rings. While it's out I'm replacing fuel rails with Division X rails and replacing the engine mounts with Steeda adjustable mounts. Adding a J&S Safeguard Vampire. Can you think of any other relatively inexpensive mods that would be easier to make with the engine on the...

I'm trying to find out if anyone has used the MSD ASY29003 wiring harness on a GT500. Just want to know if it'll fit under our coil covers. Here's a link to a picture: https://picasaweb.google.com/JohnPizzuto/JSVampireInstallation#5839241173183947106

How difficult is it and is there anything weird I need to look out for?

Anyone with a 2010 who has installed one of these devices? I'm thinking of buying one and would like some guidance on installation.

Where is it located?

Wow, what a difference a new clutch and heavier flywheel make. And the tech found a clip on one of the shifter support arms was loose and he put it back in the proper position. Shifts are back to being smooth. I have 44 miles of 500 break-in miles now on the clutch. An added benefit - gas...

Looking for fronts for my Steeda Spyder wheels 20 X 9.5. Toyo R888s are wearing out. Will NOT be putting R888s on the front again. I need a recommendation for well-behaved all season performance tires.

My McLeod RXT is slipping. Now would be a good time for a sale and free shipping on a new clutch.

Just called Ford dealer who said to get the fuel line you have to get the rails too. Wow, how can that be? Anyone know where to get just the crossover line?

Does anyone have a diagram that tells me where the accessory belt tensioner is? I just received the larger pulley for my alternator. I'll probably put it on sometime this week.