I have a bad feeling my alternator is tapping out. So, I get the car out of storage and go to start it. RRR RRR click click click. :dw: I hook up a spare battery from my boat with some jumper cables. Start the car and leave the battery hooked up for a few to let the battery charge a bit before I...
Is it mechanical, or electrical? Where is it? Is there a way to test the flow rate? I took the car out of storage, started it up and let it warm up. Fans kicked on, pump started pumping very rapidly. Everything looked good. Did about 80 miles or so of off and on driving today. Let it cool down...
My rear diff was leaking so I took it out to reseal. I popped of the cover and there was a considerable amount of gray sludge on the plug. I am assuming that is powdered metal stuck to the magnet on the plug. I guess in an ideal situation there would be none there, but how much is acceptable...
Just bought some ebc greenstuff for the front and rear. Pulled the rotors to have them turned. 28k miles and supposedly the rears are under spec. Not sure about the front, don't know the spec. Anyone have it?
FS: 2 satin 03 cobra wheels ** updated w/pics **
Just like it says 2 03/04 cobra wheels satin finish, not chrome. 17x9 with the svt center caps. $230 shipped. Been in the garage for a while, a little dusty right now. They need a bath and the hose is frozen!!
Does anyone have any recomendations for a local tint shop. I have a vert, and would like to tint the sides and back. Any estimates on a price? Thanks :beer:
Last year I decided to replace the bushings in the irs. I have urethane in the irs cradle, alunimum in the front diff, and delrin in the rear diff upper control arms and lower control arms. After 3000 miles or so I developed a squeek which I tracked to the driver's side lower control arm. I...
I installed the maximum morotsports rear urethane isolators with my h&r springs. I put the flat one on top, and the one that has the cutout for the end of the spring on the bottom. Is this right, or do they go the other way around?
Did anyone have trouble getting the pinion angle right when using nicks bushings? I can't seem to get mine right. I have the front of the diff as high as it will go, and that doesn't seem to be enough. I have the aluminum inserts in the ears of the diff and a big stack of washer on he bottom...