I have been racing, modding and improving this car for over two years. It has been a great car and I have had a ton of fun with it. However, I have found myself not racing much lately and the car is going to waste. I just swapped in an all fresh, all new forged iron 370 and a billet Borg S484...
Nitrous Outlet Hardline Plate kit for Coyote. This is a complete kit. I have all of the jets, including a set of 125s that I bought. Top of the line Nitrous Outlet bottle warmer and pressure switch (heats the bottle incredibly fast), pressure gauge on the bottle. NOS window switch and Nitrous...
Still dialing in this new forged LQ4 and BW S480 combo. Kept blowing intercooler pipes off, so this was the only clean pass. I was hoping to pour 18-20 psi to it and up the timing, but it was not happening. This was a 15 psi, give or take, run with only 12 degrees of timing. My goal is to get...
Yep, this will fit with some grinding on the caliper with an angle grinder. I went slowly, painting the caliper after each grind session and rolling back and forth in the driveway until it stopped rubbing paint off. In the end, I did not take much off. Not as nice as a Race Star/Weld/Bogart...
This was my very first pass. Ran the car on wastegate alone, which is 13 psi average boost. Cut a pretty lazy 60 foot on the anti-lag and about 6-7 psi. I will have to work on that. I made one more pass on higher boost (around 17), but spun to a 2.0 and went 10.55 @ 136. I got warned before the...
I took an old friend for a ride today, here are the results:
Spalt takes the Fairmont Challenge....5.3 Turbo LSx Fairmont Ride Along - YouTube
This car is too much fun.
Mike
Just a short little pull in the turbo LSx Fairmont. This thing piles up speed at an alarming rate, so you really can only get into it for a few seconds at a time on the street......
650 RWHP 5.3 LSx Turbo Fairmont Quick Blast Helmet Cam - YouTube
This is about a month old. Was on my 408 that is now sold. The sensor itself has about 20 miles on it, and about 30 minutes of operation. Comes with all parts (bung, manual, etc.).
These are known to be among the most accurate wideband setups you can buy for your car. Easy to install, you can...
Ultimate CCW Drag Setup for Coyote, Wheels and Tires $2,000.
I have now owned these twice, LOL. I keep thinking that I want to race the Mustang again, but then I decide not to. Tires still have less than 10 passes on them and are in great shape. Wheels are just about perfect.
CCW drag...
Installed it today.
The install was relatively easy. It was a bitch to remove the rear clips that hold the wiring harness to the back of the intake, so they got the wire cutter. The LMR "install" kit that assists with relocating the purge line is a waste of time. I used the line and the...
If the weather permits, I am going to finally get this Boss intake on my car. Any tips from people that have done it? Any special tools needed?
Thanks,
Mike