Recent content by Om3ga47

May consider trades plus cash or Honda CBR600 or a car, preferably something 4 cyl and manual. Will consider classic cars, preferably Ford. When you email me with a trade offer, please send pictures it does help you know. NO TRUCKS. NO HONDAS NO ACURAS. (cars) CAR WILL PASS CA SMOG Up for...

I have a H/C/I 5.0 that needs some tuning. I can not bring myself to give a stranger $300+ for a tune, not to mention I still need to drop another $300 on a chip. I am looking for something affordable that obviously works. Any recommendations on a certain chip/software?

Buying some soon...GO!

Looking at some Weld drag lites. For my notch. What is our bolt pattern for our 4 lug? I want 3.5" in front and 8" in rear, what backspacing am I looking for? Can a 9" fit in rear? Any help and pics are appreciated, thank you.

I have a 90 Coupe and just ordered a B&M pro ratchet for it, trying to get mounting ideas, however I want to see them all. Post what you got! Not the shifter I ordered but close, found this on LS1TECH.com, clean install!

Only has 7 views so far, came across it on facebook... freaking great. YouTube- Parking Structure Terminator Brakestand

***READ*** The car on the left bank is running low on compression,dont ask because I don't remember the numbers. This is not because of the nitrous kit because I was never able to use it. No oil in coolant or vice versa. I have yet to check the coolant for carbons and it doesn't consume oil. I...

HDR HDR HDR

On top end or a good load. Has happened in fourth each time,I am WOT,about 4000-6400 and I am getting a heavy vibration with hardly any power to accelerate. Am a bit worried,yet to compression test but want to see if anyone has had this problem.

Soon to be rebuilding my motor. I wish to go JE Pistons and rods if they make them,if not maybe eagle. ANy suggestions on what to use? WHat brand? Flat top or dish? SHould I even bother getting rods?

Need to pull the motor soon,she is hurtin'. Any write ups out there for this car? I am used to pulling engines out of a particular trans am but its tubular K and only necessary equipment make that job easier. The Cobras look like a world of hell when thinking of pulling the motor. SO who knows...

Charcoal/Silver suede rear seats,need as well rear passenger interior panel and both (Front and rear) passenger seat belts. Please dont come as 700 for your rear seats alone because im not stupid,work me out a deal on all items and you will have cash in your pocket.

Getting to expensive for me at the moment.Car has 60,xxx Car was never tortured nor pushed too hard. Always clean and cared for and of course garaged. Never smoked in. Asking $19,900 or take over payments and maybe a little cash if your serious,if your just a tire kicker dont waste my time.. It...

Just recently I noticed (Not sure how long it has been happening...) but I see no fluid movement in the intercooler tank. Does anyone have any ideas or have experienced this? Before we go right off and say BAD PUMP!!! I want to know if there are any other quirks that could cause this...and yes I...

Just curious. Going to do a bearing and coupler replacement. Has anyone removed the snout without actually pulling the blower?