They said don't waste the $$, if I am not racing or turning motor over 6k. L&M said the same. So I dropped off car for cams only. Will buy a built motor in time.
What is the best guess as to max rwhp for 2011 GT500 stock motor internals? Getting cams done but I am at around 720rwhp now. Had to pull timing to get me down to that. What is the general consensus on what this motor will take? Thanks in advance.
Just getting input . I have a 2011 (aluminum block) with no issues but I am over 700rwhp and about to do cams... So knowing I am about the limit I am Either gonna rebuild my motor or get a short block. So the question...
1. Should I Sell my short block buy a built short block or just...
Has anybody used a Ford Racing one piece aluminum drive shaft? I am looking at option and see the DSS as the one most people go wth but then I saw "new" Ford Racing model on LMR and was just curious. Also looking at the blowfish Racing shifter support bracket with integrated drive shaft safety...
Back ground: I Have had more mustangs than I have fingers and recently found a 01' lightning with a built motor (fox lake which I am researching) it has a 2.3 kenne bell puts down 570/620. I have researched the truck (man lightning community is so tight ) and found previous owners which is...
2001 Silver Lightning
$15,000 if you like to haggle, $13,500 if you wanna buy it. miles are 110k,
I bougth the truck and it is not for me. I was replacing my GT500 but I am just not into the lightning. This is the ad from the guy I bought it from. I got it and changed all fluids, oil, and...
Anybody running these springs? I am mostly on the street but at over 700rwhp even on a roll it can be hand full... Just curious if anyone has tried them and what t the feedback is on them, thanks.