Recent content by vr4

  1. V

    First Time Dyno. What should I have made? What next?

    HP tuners?
  2. V

    03 cobra Memory steer/ sticky steering after new inner & outer tie rods

    have you gotten an alignment?
  3. V

    Head cooling mod, UPR, EBay, MMR etc. Any difference?

    i have mmr. fit was just fine if you dont mind removing egr.
  4. V

    Rear big brake kit?

    https://svtperformance.com/threads/fixing-sn-95-big-brake-bias-14-13-14-gt500-rear-rotors-on-irs-bias-calculator-for-common-brakes.1211983/ I have a set of the brackets. They are very nice but havent installed yet as im working on other parts of the car for now.
  5. V

    Borla stinger tailpipes not aligned and touching

    holy crap. thats insane. i work in an exhaust shop and we would probably charge about 200 for that. i agree with others. loosen everything so its just barely snug and move everything around until its where you like it then tighten down.
  6. V

    Looking to buy a roller what’s a fair price

    Agreed. Smoked engine, missing trans, probably missing some other fairly hard to find/expensive small parts. 8-10k at the most. These cars are expensive to build piece by piece. I picked mine up for 5k and had a complete crashed car to build from. Cost wise I maybe came out on top but labor...
  7. V

    I wouldnt say i was screwed over but....

    My first one i bought in 06. turns out it had been crashed (entire right side of the car had been replaced. Rear quarter and all. It was very well done and the only reason i had a suspicion was a real light wrinkle in the trunk floor. Confirmed it after it got stolen crashed. Cut it up after i...
  8. V

    Fpdm relay

    Pretty sure the part number for that is 4U2Z-14S411-EB disclaimer: Im not a parts guy and havent worked for Ford since 2009
  9. V

    Made mistake bought modded Terminator

    Don't know how I missed that. Agreed. Gonna have to go back to damn near stock.
  10. V

    Made mistake bought modded Terminator

    this. its usually the dealers responsibility to make sure the vehicle will pass emissions...
  11. V

    Crate engine

    If it's a reman there will be a silver plate on the block. If it was replaced while the car was still in production it would have an engine that was "pulled off the line". It comes to the dealer fully dressed. All accessories, wiring, belts, etc. in that case it wouldn't have the plate but it...
  12. V

    Normal STFT high LTFT

    PCV hose under the intake.
  13. V

    3 inch catback

    i ordered mine in june of 22. they shipped 4 months later almost to the day. i feel for you. that 4 month wait was tough even though the car was just sititng.
  14. V

    03 cobra starter issue

    Yeah either shave the tabs off or get denso sensors. They don't have tabs.
  15. V

    Emissions test

    word has it they've gotten more strict.
See more

Top