Hi Guys, very sad to be selling the best vehicle I have ever owned - my 32V TT Lightning. This amazing vehicle was featured in Ford Truck Magazine and was one of the first ( probably THE first ) 32V Twin Turbo's ever produced. This truck has been constantly improved over the years and has had...
Complete and ready to bolt on pair of professionally ported/flowed/polished FR500 heads that have been adapted to accept the Navigator inlet. If you're into a 4V Turbo conversion these are the heads for you to make very serious power. Over $7,000 have been spent on these heads to bring them up...
Planning to do the center console mod, but who can I trust to cut and upholster my passenger seat anywhere near Central Florida? Has anyone had this done here with good results? Also, has anyone fitted an extra drivers seat on the passenger's side? Would it work even with the controls on the...
SOLD
YouTube- Barry's 01 Lightning777
Anyone who knows me or knows this truck will also know that this truck is a bargain at the price I’m asking … $11,000
I have spent thousands and thousands on all the supporting mods necessary readying for a built motor to be dropped in. It currently...
Just wondering if 15" on the front have the look of 'too much tire'. I have to run a 28" diameter tire on the front for ground clearance issues. Thanks.
Despite help from some members I am still looking for some reasonably priced 17x11 rims to run the biggy M&H's. The TF wheels are $550 a piece which is too rich for my blood at the moment. What else is out there guys?
Not impressed with the Nitto DRs for regular road use. Sure, they're a good compromise and hook pretty well at the track after a roasting but I'm looking for a road tire to handle my 630 rwhp with less slippage ( is that a word? ) when I floor it. So what are you big hp guys using for daily driving?
I have a twenty gal sumpted ( is that a word ) aluminum fuel cell mounted in the bed. It had a roll over venting valve fitted that just vented into the air but this allowed fuel to 'splash' out when full and it stunk. So I have swapped it out for a roll over valve that has an #8 AN male thread...
Didn't realize there are several converters available ( apart from the obvious stall options ). I want to go with a 2400 stall for my TT 624 rwhp truck, which P.I. are you using guys?
If I remove the rear bumper, the lower molding above the exhaust tips, and detach the filler neck from the bodywork and remove the rear wheels, is it possible to just slide the bed far back enough ( I would think about a foot ) to access the fuel top hat to replace the pumps. Fed up with...
Hi Guys. Been away ( no, not lockup :-) for a while and haven't been using my truck for ages. Well, I'm back using it and I want to get back to fixing my bad fuel pressure problem. It's worse than ever now - 18 at idle and drops to around 12 even under mild acceration. When I last was into...
SORRY SOLD Hi Guys, up for sale is my JLP motor, out of the truck, clean, and on a stand (included). There's nothing drastically wrong (nothing broken, vented, or anything like that) but it has poor compression on two cylinders and has a few loose spark thread inserts. I have to realize that...
Hi Guys, anyone know how much it weighs? I'm rigging up a hoist and I would like not to pull my garage ceiling down. I know two or three guys can easily manage it, but just how much does it weigh? Thanks.
OK, so my so-called piece of Krap built motor has mercifully expired and I'm about to drop in an 03 stock long block with a stock Eaton and 4# lower to get me up and running again until I get a new built motor put together. Now, this new built motor will take at least a few months to put...