Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
T56 Input shaft end play
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="88foxbod" data-source="post: 12564831" data-attributes="member: 122915"><p>My TOB recently spun itself to death so I decided to make the swap to the newer style Liberty 26 spline input shaft. I've read up on alot of the posts about checking endplay. </p><p>The stock shim was .040, so I tried that out first and got ZERO movement. So to avoid it being too tight I went down a few sizes.... I did this about 7 times and finally got down to my smallest shim at .029 and still NOTHING.</p><p>The only time I get indication of movement is if I pull out and wiggle the input shaft a little, otherwise there is no in/out movement.</p><p>Has anyone else used that small of a shim? If I throw in a .034 shim, pull and wiggle the input shaft, it shows about .0015 movement. </p><p>Is it acceptable to wiggle this input shaft or is it supposed to be strictly push/pull movement?</p></blockquote><p></p>
[QUOTE="88foxbod, post: 12564831, member: 122915"] My TOB recently spun itself to death so I decided to make the swap to the newer style Liberty 26 spline input shaft. I've read up on alot of the posts about checking endplay. The stock shim was .040, so I tried that out first and got ZERO movement. So to avoid it being too tight I went down a few sizes.... I did this about 7 times and finally got down to my smallest shim at .029 and still NOTHING. The only time I get indication of movement is if I pull out and wiggle the input shaft a little, otherwise there is no in/out movement. Has anyone else used that small of a shim? If I throw in a .034 shim, pull and wiggle the input shaft, it shows about .0015 movement. Is it acceptable to wiggle this input shaft or is it supposed to be strictly push/pull movement? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
T56 Input shaft end play
Top