99 Cobra driveshaft

[onesteggysquid]

Probably a newbie question, doing a t56 swap in my 99 cobra. Will the terminator driveshaft bolt right up to my diff or do I need a hybrid u-joint/pinion flange swap to bolt it up? I've been searching the forums but can't seem to find the right info and I personally don't see how the u-joint would make a difference in whether it mounts to the driveshaft or not.


Sent from my iPhone using the svtperformance.com mobile app

 

[01yellercobra]

You'll need a hybrid u-joint to mate the drive shaft to the correct size pinion flange. The holes in the 03/04 driveshaft are bigger. The hybrid joint has the larger bearings for the driveshaft and smaller bearings for the 99/01 flange.

Sent from my SAMSUNG-SM-G935A using Tapatalk

 

[onesteggysquid]

So what I'm tracking off of that is the rear flange off of the 03/04 DS comes off and I use the hybrid U-Joint to out the flange off my 99 DS on the termi DS?


Sent from my iPhone using svtperformance.com

 

[01yellercobra]

Correct. The pinion flange on the 03/04 is larger.

I think this is what you need. You might be able to find it at Napa.

https://www.summitracing.com/parts/...0AzuJ5m3gav3atjkBumsauD6CkrFUkEyT0RoCqjrw_wcB