Recent content by 97Stangv6

Has anyone installed a single deck radio in their car? I installed a 03 dash in my car and its a 98. My radio is aftermarket also. Thanks.

I was cited for Improper lane change based off what i told the officer. I was coming off a exit that has two lanes(becomes a new road), I was going about 10mph over the post safe limit.(Yellow signs) I went to switch from the right to the left lane just before the corner. As i completed the...

I've read a few guides, but i was wondering if anyone here could give some advice. I have a small Black & Decker rotary tool, like a Dremel. Can i use it for this? If not whats a recomended tool/kits that wont leave me broke?(Spent over 6k on this build so far and its not even together yet...

I've called every frpp dealer in my state and i've talked to FORDSVTPARTS, with no luck. The kit was recently discontinued. I'm looking for the valvetrain kit, it includes valves, springs, and seals. The part # is M-6500-T46 If anyone knows where i can find this or even has it and is willing...

I just pulled all this off my car a few months ago. I'm going with 01 heads so i need to sell this so i can get a 01 intake. The motor was overhauled less then 10k miles ago so all the gaskets are in very good condition. I cleaned the intake up a little but have'nt had a chance to clean the...

Does anyone know if you can use a 98 T/B on a 99-00 intake? They look very almost the same except the 99-00 looks like its flipped in pictures compared to the 98. I do know that they do have different part #'s though. Reason being i'm putting c heads (01's) on my 98. Thanks.

Has anyone seen the bike crash compilation with the song "I hurt my self....again" ? I've seen it on youtube.com but i searched for a hour and couldnt find it. Thanks.

Does anyone know the difference between these cams?

I accidentally smashed the head on top of one of the cams and this is the result. Is this head still good/fixable? This all happend on Cylinder #1 (Passenger side head at the front). I would really hate to have to find another head/pair of heads as i JUST bought these Saturday. And i got a...

I've talked with my local tuner and he thinks that a single 67mm will be good for 600-650rwhp on pump gas like 15psi for a daily driver. And the most it could push is 700 with race gas. Now not that 700 isnt a lot but i would really like to be closer to 800 on race gas. Another thing, is a...

Is it possible? I'm talking out the top not removing the k-member as i dont have a body lift. Also whats a good place to connect a chain on the front of the engine? Considering it will lift the tranny also. If its not posssible with tranny, still whats a good place? I will have a load...

Does anyone know which one will hold up best on say a road course. Which one will have the least heat soak? Thanks.

I'm looking for pics that will give me a idea of ground clearence and tranny clearence(when dropping the tranny). I would like pics of every brand but what ever you have post it up. Thanks.

Can someone give me a list of sites/fourms that would be good to browse for used parts. Specifficaly a used/new t-56/trannys. Thanks.

I just put a new belt on becuase this happend to my old one: So i bought a new one from ford about 1 week ago and now its split about a 1/3 of the way around the belt right down the middle. I;ve been drving with it like that and it hasnt broke yet. The only reason i found out it was split...