thanks guys I'm trying to look over all the wires and connections to be correct after the Paul's High Performance fiasco. All around and behind the intake areas thanks if you can help.:beer:
Also a pic of the computer and how it is mounted under the
p-side kickplate I have one screw and one...
It only comes with two screws. What did you guys do beyond just attaching those? Two sided tape? Also do I need to do anything with the extra factory holes. Please give me all the details. thanks:beer:
I was searching and had no luck. Even though I know I've seen them here before. Please post them again for me in here if you guy's would. Thanks. P.S. On the car is what I'm looking for.:beer:
Well guy's (girls) I really hoped I would have better news but.....
I went to Paul's today to try resolve this situation. He put my car back to the way it was before the $2200 I spent, to do a baseline dyno run. Unfortunately my mint intakes had been modified already so he used someone elses...
Paul's High Performance exposed letter attached
Some of you may have gotten pieces of my horrible experience with Paul's High Performance. I am attaching the letter I sent to him after I went to him and spent $2200 and got poor results and ZERO customer service from him. He just keeps blowing...
What are the numbers for the 50th anniversary vette? HP & 1/4 mile time and 1/4 mile speed. What exactly are the performance differences vs. last years plain old regular vettes. Also what upgrades have they added (like exhaust or anything right from the factory). Thanks
I just can't figure...
My pedal on the old 91' 5.0 goes to the floor. I can pump it back up but if I hold it down it will slowly make it's way back down to the floor. I have bled them and refilled with new fluid but no luck. Any help would be great thanks.:beer:
I'm guessing he might come on here. Bearded guy, always getting on it. Pulley SCREAMING Loud. I saw it haulin ass at me today on Ford Rd. and I could here the pulley about an 1/8th mile away coming towards me. Anyway, are you on here? I want to know your engine mods (size pulley, if you have...
Someone doesn't stand behind their work and that's an understatement. This is not right and everyone into Mustangs knows of this place and these people. Why should anyone else get ripped off of a lot of money?:cuss:
Can a shop tell you you gained power when you didn't? Can they make a before dyno run look worse, and an after dyno run look better somehow? Or am I just paranoid after a really bad experiance.
My friend has an 03'. He told me that he downshifted to 2nd gear (not sure of speed) probably 35 to 40 mph. He said the car cut out on him and that the supercharger light was temporarily flashing. I assumed Trac control cause the tires very well could have started to slip. But what's up with the...
Where can I get a good allignment in Michigan? I have 18's and don't want my wheels scratched also car is lowered but I do have Caster Camber plates. Why is this so difficult? I had two done this morning and it's still out of specs (caster and toe). WTF:gt: