Recent content by blown03svt

Does somebody by chance know what a stage III (F) spec clutch looks like or is using one ?? I ordered a clutch from spec, They said with my combo I would need a stage V , but called me back a said I need a stage III F some special material??? anyway I agreed . SO the material to make it would...

Well today I was lucky enough to test some of the 275/40/17 drag radials for mickeythompson, some new compund they are trying, I ran a [email protected] on the new compund w/ a 1.79 60ft, I'm sure I could of done a little better! BUT only 2 passes were made before the rain hit :cuss: I was hoping...

What does an eaton sound like when failing??????? 13k miles with upper 2.8 and lower 4lb, When I rev to 2200 to 2500 A noise from the heaton, sounds like marbles inside??? I can purchase a new blower for about a grand, but in order to stop premature failure what mods would you do...

Are the ngk iridium tr55ix ok for 15#'s of boost, lately after shifting 2nd, now 3rd the car noses over then comes on strong!! more cold conditions, than operating temps. Also picked up NX system, I'm planning to run 75 shot with a tune!! Any input would help please!!!!!!! :bash:

alum or steel???????? which is better?? I ordered a a.s.p steel. Did I f%^&k up????????:cuss:

Anyone running 3.90 gears or 4.10's, hows the driveability on the street??? I recently purchased 26x11.90/17's et streets, Put them on stock cobra wheels, The et was better but lost 5 mph. I have been told you do loose a few, But 5 mph, the drag radials I use are 315's I have trapped 125.77...

This is my best mph/Now I need to work on et. The vid is a little poor quality!! Click 4 vid

would anyone host a small vid for me??? my best mph pass!!! 03 cobra w/ some stuff:beer:

heat exchanger mods?? What mods are helping?

The horse power is for real!! the driver was bad!! there is a few problems with the car, I should be ok in the rematch!! props to the zo6:rockon: