I am going a different direction and looking to sell these rear brake parts. All of it is brand new unused and never mounted.
Rear EBC rotors in black GD7154
Stifflers Rear Stainless brake line kit in clear
Hawk Ceramic Pads 301Z630
BGRacing ground calipers(comes with a second set of...
These injectors were installed in my truck and received dyno time and maybe 15miles street use and I found the shop tuning my truck was incompetent and couldn't tune the injectors after they were sent to RC and checked for any problems. So what I have is a set of 8 RC Engineering 750cc injectors...
stiegemeier stage 3 ported blower with powerfin and stripped rotors. fully ported and port matched plenum. Less then 10k miles on the blower itself. 2.93 upper. The blower is for 01+ but will fit 99-00 if you drill the 2 additional holes.. It is a 04 blower core.
money order...
stiegmeir stage 3 ported blower with powerfin and stripped rotors. fully ported and port matched plenum not done by stieg. Less then 10k miles on the blower. 2.93 upper. $800 shipped
money order, cashiers check, personal check or paypal+3% fees.
genuine Factory Tech 2CR valve body. 200 shipped.
custom valve body. it started out life as a 2CR from factory tech but it shifted soft as ever and Tim wouldn't give me a refund on it. It had less then 20 miles on it so I bought new valves, springs and modulator from sonnax and built my...
anyone have a copy of the afco pro series heat exchanger directions. There weren't any in the box and I think there are some nuts/bolts missing. Just want to be sure I have everything.
stock 42lb injectors 30k miles $200shipped
solid 4lb lower. I might have a belt for this also. $75 shipped
polished aem intake with dryflow filter minus heat shield needs some polishing. $100 shipped
stieg stage 3 ported blower with powerfin and stripped rotors. fully ported and port...
This is for anyone who has one installed. I am looking for a measurement on the 3.4 so I can finish an intake before the new motor goes in. I am looking for the distance from drivers side fender to the lip of the TB closest to the blower. Basically the outside edge of the silicone coupler used...
I figured I would post some pics of the power steering relocation I did today. I used the 4R3Z3A697AA 05+ mustang reservoir which has side barbs on it versus the bottom on the stocker and it has a nice mounting tab on it. I did this to make room for the new valve covers. It fit nicely on one of...