Recent content by bubbal00ve

So this might be a dumb question but I would like to know what oil weight do you guys use??? 5-30 10-30 or ?????? I've been told by many engine builders to use 5-30 then 10-30... I have the MMR 600 short block, flat top pistons and eagle rods, comp 10.1.0, no adder powers or nitrous. So what...

I cant decide which one to buy the T-trim or Si trim and which si trim the V1 or V2. please chim in with your opinion.. 96 cobra mods are, mmr 600 short block, manly flat top pistons comp ratio 10.5.1, manly rods, stock heads, Hooker Lt's, hooker x pipe, sct CAN tune. No fuel mods but will be...

I'm getting my short block built and all i need is the gaskets for the IMRC's and cant find them. I've called the dealerships, auto parts, and tried looking for them online but they only offer the gaskets if you by the IMRC's. and the dealership have said that they dont have them because they...

I have a 96 mustang cobra. how do you adjust the timing on these cars? my car idles up and down and somtimes it will shut off. and i've lost so much power. thanks for everyones help.

i just installed Lts hooker headers. everything was good but, i noticed that my air bag light was on but it will turn off and on three times then turn off for like 15 sec then it will do it again. then i drove it for a while then decided to go full throttle so i did. but i noticed a power loss...

ok well am looking to buy some long tubes headers and a x pipe for my 96 mustang cobra. i've read alot of different forums saying that it was very difficult to install. I also have read it depends on what brand you buy. so i need some good advice about which setup to go with. so it wont be a...

am looking to buy some heads for my 96 cobra i just dont know what kind of set up to go with, I heard the 03/04 cobra heads or pretty good. am looking to spray nitrous on my cobra. If any of you guys have suggestions please let me know. THANXS.