I have a set of front coil overs with hyperco springs.. I got these awhile ago and never used them.. The hyperco springs are 8" Dia. 425 in/lb looking to get 150 for everything..
Coil over kit I brought from a member and never used.. They where set up on my koni struts and they also work on tokico struts.. Hyperco coil spring is a 8" DIA and 10" long 425 lbs spring..
Looking to get 250 shipped
I have set of brand new MM extreme duty control arms for a 79-98 mustang MMRLCA -30.3.31.3. I had these for awhile and haven't used them. There is damage to one of the spherical bearings from when they were shipped.. ( see pictures) these are set up for coil overs and they have sway bars mount...
Well it's been 2 week of checking every connection, wire, ground and still no power to the fuel pump.... Here's alittle back ground... I was driving doing about 45-50 MPH and the car just shut down. I though it was a fuse or relay maybe even the fuel pump... I checked under the hood and my fuel...
OK im going crazy and i need help.... I was driving to work doing about
45mph and the car just died... The day before i ran the tank empt... I add 2
gallons of fuel car starts up... I get the car towed and i do a search and i check every fuse under the hood i change the CCRM, the 2-step relay...
I'm stuck trying to found out what would work best for me....
I have a PC new in the box all the different pads of different
sizes... I'm stuck on which product to buy and use............
I have 98 cobra BLK on BLK and a BLK/BLK BMW 545I both
have good paint but could use some TLC. Here's...
I have a set of complete 98 cobra B-heads stage 2 CNC ported
and polished cyl. heads done by FORD PERFORMANCE SOLUITION
They have about 30k run time and came off my built stoker.....
They have viton seals, stock springs, bronze guides, stainles steel
valves... Was asking 1200 plus shipping...
I'm selling a set of 98 cobra CNC ported B-heads. They
come ready to bolt on and run with stainless steel valves,
viton seals,bronze guides, springs and stock 96-98 cams.
They were CNC ported by FORD PERFORMANCE SOLUITION
I'm asking 1200 plus shipping OBO
I have a set of CNC ported B-heads off my built
98 cobra. Its a stage 2 port and polished from
FORD PERFORMANCE SOLUITION. It comes w/ stainless
steel valves, viton seals, bronze guides, stock springs,followers,
and cams. The heads have about 30k in run time and are ready
to bolt on and...