Catmonkey's latest activity

Absolutely. I am old too. I'm sure 50 years ago I would have thought otherwise.

Poly engine mounts will do the same thing as bolting that monstrosity to the bell housing. The problem is the liquid filled engine...

All things being equal, that difference in trap speed equates to 45 rwhp on a 4300 lb car with driver. 3 mph might not sound like much...

I pretty sure 2010 to 2014 use the same flywheel, so you should be okay. 13 inches from ride height should be enough. You can tilt the...

Ask your tuner if he changed any DBW settings. The car will run with that throttle body without any changes, but it will run a lot...

There are a few good GT500 tuners out there. I use Lund Racing but BJ McCarty at Venomous Tuning is highly regarded as well. See post #3...

Note, I said "as cast". We're not talking ported or aftermarket elbows. Gen 2 doesn't have the bolt on elbow, so it wasn't as...

There were various iterations of the 2.3 TVS. Better flow tends to follow the historical chronology as follows, for an "as cast"...

This is not the first time this has been posted here. I don't know the answer, but I'd try to locate a 2010 GT500 PCM from either ebay...

Cams will drop your dynamic compression ratio. I'd put a little more compression in it, at least 9.0:1.

I didn't need to train OEM sensors. I did need to train aftermarket sensors.

Another consideration might be mile racing. 3.73s will limit your 5th gear speed to around 185 mph, depending on rpm and tire choice...