Recent content by DonnieDarko

These are all remaining parts that I have from my Cobra, they are either new or in like new condition. All Prices include shipping. I ship with USPS Priority Mail with Delivery Confirmation either same day (If before 4PM) or next day in the morning after Payment is recieved. I only accept...

My passenger side front tire keeps deflating to 6 PSI. I fill it up to 35 PSI and in about 3 days it's down to 6 PSI. I listen for any air leaking but cannot hear any and after looking around the tire I can't see any holes. What can be causing this? Should I just buy new front tires?

Vid request of 04 cobra throttle getting stuck Does anybody have the video of HISSMAN's dyno where the throttle gets stuck at WOT? Also theres another video in a 1/4 mile race where he shifts into 2nd gear and the throttle gets stuck and hits the rev limiter like 13 times. Please post if you...

I just want to know how would you go on about to tell if you have the January 2005 revised heads? Also is the LDC Cooling Mod needed if you have the Jan '05 heads?

Whenever I slightly rev the engine, I hear this marble in a tin can sound. Interesting because I just got my cylinder head replaced about 2 month ago. Not sure if they put the Jan 2005 Revised Heads but logically I would think they would have. VIDEO...

I have a Magnaflow cat back and I am looking to install a MAC 2.5" H Pipe (No Cats) and I am just wondering how will it sound? Also does anyone know the exact steps to remove the "Check Engine Light" using the Predator?

when trying to balance out the clutch and go in first gear the gas pedal is sort of hard to push down...almost like it's sticky, then it goes in. I looked under the hood and where you revv the engine, that Grey Plastic thingy broke off of the shaft. Could this be the problem? The car ran fine...

I'm planning on removing the cylinder heads to replace them and was wondering does the Supercharger need to be removed and all of the Lower Intake Manifold (gold bolts) need to be removed in order to switch out the heads? Also how long of a job to replace the Valve Cover Gasket because his is...

http://videos.streetfire.net/Player.aspx?fileid=87AEFACA-5E1E-4A36-A164-F193BA0D9228 :rockon: