I normally don't drive it when < 50 degrees but it was 35 this morning. All was normal until I rev'd above about 5K and this whine started when the engine came back to idle and at a stop. It varied with rpm but pretty much went away after 2K or so. After driving on the xpressway for about 20...
Can anyone tell me the size of the JLT RAI filter? I currently have the JLT CAI and love it but unfortunately since it's a daily driver and road construction the filter just gets too messed up in the well.
Thanks
Guys,
Specifically I'm looking for a 30-50 second gear run, I've consistently gotten 1.7sec. in the past. I haven't re-run it yet but it seems my power is a bit off, I'd like to know if it's a good benchmark.
The reason for 2nd gear is no wheelspin to fudge up the measurement. I also have...
Anyone done this?
They say 9.5" but I have the tires already and will be using my stock 9" wheels. I think guys have done this but just wanted to verify.
Thanks!
Here's some numbers from the July MT:
1/4 mi. 12.7 @ 116
lateral accel .92g
braking 60-0 110ft.
weight 3944lb 57/43
base price $41,950
I wouldn't mind having one.
How are they between 40-60deg? My F1's get pretty slick under 70deg, I'm looking for something that's half way drivable at colder temps too. (I have Blizzacks for the snow)
Thanks
Anyone else have a loose front bumper? I can lift mine up about 1" right where the fog light is. I looked under there and saw no way to tighten it either, any help in this area would be appreciated too.
Thanks
What are these things about? I saw one of each today on the way home, how fast are they? They didn't say M5 or M3 but just like I said in the title on the right rear of the car.
Thanks
I want to keep the stock look so I'm going with a 3.1. I would also like to buy mine from billetflow but I want a one piece pulley, not the hub and pulley assembly. I do not see billetflow advertising the one piece units. Does anyone have a recommendation of another manufacturer of one piece...
Guys,
I don't want to mess up anything saved in my predator but I was wondering has anyone used their predator to read and clear obd codes on another vehicle?
Thanks
I know it can vary all over the place but what do you guys think the following mods can run give or take a few .1's.
JLT CAI
Magnaflow Catback
3.1 pulley
Predator & tune by RWTD
Everything else stock.
Thanks
Guys,
When speed shifting quite frequently I miss the 1-2 shift because not pushing in the clutch enough. I want to get a UPR Quadrant and Firewall Adjuster but I'm not sure if the Speed Relase one will allow me to raise the clutch release point off of the floor enough. I'm thinking the Triple...
Guys,
My engagement point is real close to the floor, I'd like to raise it some. The ergonomics are bad on this car so I have to stretch to release the clutch and it causes me to miss shifts because of not releasing the clutch all the way. Of course I could move the seat forward but then I'm...
I've noticed abrasion where the back of the side scoops touch the body. It's like the scoops are rubbing into the clearcoat and leaving white marks. Has anyone else seen this? This makes me real nervous because I had an '89 taurus with lower body cladding that had the paint bubble and eventually...