Recent content by Force-fed04

Update I went ahead and purchased the aluminum 2001 cobra driveshaft and it works great 44 and a half inches from Center of U-joint to U-joint straight swap in for me solid rear axle w/ T56 Cobra R-Spec trans Sent from my Z981 using the svtperformance.com mobile app

Yes allegedly did try to get me to purchase his old Svt which was in fact a contour SVT. Allegend123 ,also has some opinions on people that drive Mustangs .. of course pre-me talking him into getting one. Keep in mind I'm only 20 minutes up the road from you. And this is how I deal with...

Hopefully this helps somebody I was struggling with finding straight answers on the a driveshaft for the six speed swap I know there's always the option of the terminator driveshaft but they're getting harder to find used and new aftermarket very expensive . American muscle sells The SR...

Thanks I definitely appreciate the response but it seems like the 04 cobra driveshafts are getting harder to find , far as I know they don't make them anymore and if you wanted a drop-in there's not many choices . So American muscle sells the aluminum driveshaft now for the 99 through 2002...

I seem to find so much conflicting information in regards to what driveshaft dimensions should be used when doing a t56 swap into a GT. Most of the shops that do the kits guard this information. So will somebody with a GT with solid rear axle and a custom driveshaft measure from the center of...

Nice ride and some nice tasteful ,useful upgrades Sent from my iPhone using svtperformance.com

Sent from my iPhone using the svtperformance.com mobile app

Yes I just bought one on eBay Sent from my iPhone using the svtperformance.com mobile app

So I have a 2004 Mustang gt tr3650 car I am swapping in a 1290 tr56 this T 56 comes with the 31 spline output shaft . So everybody says you have to cut your stock GT drive shaft down 1 inch? And the stock shaft is 45 1/2 inches "wright"? Well isn't the 99 -2002 cobra drive shaft 44-1/2 in? If...

Would that work ? does it have the same number spline on the yoke as the T 56 and will it tie in the U joint on the back of a GT ? is it any bigger around? Sent from my iPhone using the svtperformance.com mobile app

I finally got a T56 04 Cobra spec but I need a couple more odds and ends to finish the swap. I need to buy a driveshaft at a good price? Sent from my iPhone using the svtperformance.com mobile app

Yes my rods are forged supposedly will hold upwards of 700 horse what I'm worried about is my crank or if I will run out of fuel ,go lean and burn it down . Are you running race fuel or 93? Sent from my iPhone using the svtperformance.com mobile app

I have a 2004 Mustang GT 2 valve I know this is The Terminator forum but you guys know boost the best. I'm about to upgrade my transmission soon if I can find a good deal on a 6 speed (you have 1?)lol I have finally got used to the power I make now and Needmore,lol I'm looking to turn up my...

I have one of his intakes and I've been trying to get a new sticker ordered for it for quite some time, I've been having a huge problem with logging on to the website after doing some research it seems he died in 2016 .Any one know if the company is carrying on? I really liked his product...

I have a GT with a kenny bell I will hopefully be going to the 14lb pulley soon so I need a transmission that will hold A little more power pulse I would like another gear. I have already Lost 2nd. Gear in my 3650, so I need something to get me back on the road it would be nice to get a drive...