I finally got back to work on mine, install UPR bump steer kit help align mine after the team Z K member and A arms.
I also installed a meziere water pump, on with the turbo build, its just been 2 years since I've worked on it.
So I just got my roll cage installed, and I had the dash and all the interior out of the car. When I got everything back together, turned the key on no fuel pumps. I have a Fore fuel system with controller.
So I check main power and its good, I check my trigger wire that is dark green with a...
So I just got my car back, the cage came out really well, now I don't really know what to do. I was thinking about painting it but its so close to the headliner, and windshield, he really tucked it in there. I think it looks pretty clean just bare metal, maybe clean it up and wax it to keep it...
Nice cage, I'm guessing that's a prefab, are you gonna bolt it in or weld it?
I'm having a cage installed as we speak, should be done Tuesday or Wednesday. If I said I was a little nervous, that's an understatement of the year.....
I took it to the track and it went 6.48 in the 1/8 with a 1.43 60ft off the trailer. Next time I went up there, they told me I couldn't make a full pass with out a roll cage.
Thanks, I like the shifter, the only problem I'm having is when you drop it in first its to close to the rear console...
I never had any luck with the DR, I never felt any wheel hop on the street, but at the track I could feel it trying to hop. I had the FTBR kit with toe links, and I ground the knuckle to run the 15" rim, and ran a full slick. I started of launching at 4k and ended up at 5500 rpm. I don't have...
I have the Comp gears and they throw the code to, I looked for ever and couldn't find a fix. So all I need to do is add another O-ring?
The only options I found was installing the Cloyes gears or having the tuner turn it off. Neither of which I was excited about doing.
I had sometime to get the trans and relay all wired in looks a lot better. I put the console back in just so I could see how it was going to look.
I got the exhaust on the car but it took some work to make it fit, the ASB there is not much room to work with back there. I ended up having to...
I've tried that a couple of times and no luck with the grease. I took a couple of pieces of regular copy machine paper, cut them in about 2x3 pieces and soaked them in water. I just started shuving then in the hole till it got full. Then hammered in a 5/8's bolt. No movement the first time but I...
These are my drag setup and they are Billet Specialties 9.5 wide, with a 5.5 BS and there is a little over an 1" of clearance on the inner fender. Now my stock setup wont fit, I'll have to run a spacer, but I need to drill the stock hole out to accommodate the 5\8's studs.